product will not harden,after ten days the leftover glue in my mixing cup was still soft and tacky. l use many different adhesives for my projects from plastic ,cold steel weld apoxies to super glues.this product is not for me.i would never trust this product setting a precious stone or for anything else for that matter
Not so impressed with this epoxy. I tried it twice so far and each time it remained sticky after 48 hours. I easily removed the stone from the ring finding, cleaned it off, and tried again with the same unsuccessful results.
So far, not pleased with this product.
1. No instruction sheet included; can figure out use but don't understand why it is not provided from the manufacturer.
2. Unless my first use of the plunger dispensed an unequal ratio, this never seemed to fully cure, even after MORE than 24 hours; residual epoxy on my project (around crystals) still seems gummy. However, I will give it one more try, but probably just for repair, and not a new project.
3. Personally prefer a crystal-clear drying epoxy; this is amber.
4. Placed the syringe on my work table, with covered cut ends facing up, and have just found it slowly leaking down from the underside on to my table--poor construction of syringe housing.
Although this product takes time to dry, it dries beautifully. Give it 24 hrs. You really need to be patient but be sure that after you mix the two parts and apply it ,it will dry nice and clear. I also like that it doesn't dry immediately to give you time to arrange your rhinestones and it's not bulky The glue's thin layer leaves a nice and even look.