This bracelet showcases Grace Lampwork beads perfectly The beautiful ocean-themed beads look great with simple crystal bicones and JBB tube beads. Cynthia made this bracelet on a Facebook Live design challenge video. You can watch her make this piece and others here.
Cut a length of jewelry wire approximately ten inches long. Slide a sterling silver 2x2mm crimp tube onto one end, followed by a sterling silver 5.95mm open jump ring attached to half of the TierraCast antique pewter heirloom toggle set. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Repeat this pattern three times. Then, add a bicone, a squiggle bead, two bicones, a squiggle bead, and a bicone to the wire.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
This bracelet showcases Grace Lampwork beads perfectly The beautiful ocean-themed beads look great with simple crystal bicones and JBB tube beads. Cynthia made this bracelet on a Facebook Live design challenge video. You can watch her make this piece and others here.
Cut a length of jewelry wire approximately ten inches long. Slide a sterling silver 2x2mm crimp tube onto one end, followed by a sterling silver 5.95mm open jump ring attached to half of the TierraCast antique pewter heirloom toggle set. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Repeat this pattern three times. Then, add a bicone, a squiggle bead, two bicones, a squiggle bead, and a bicone to the wire.