Sunset colors inspired this jewelry set. Coppery briolette drops draw attention in both the necklace and earrings, while Forget-Me-Not flower beads bring texture. Pops of yellow are provided by bicones and an Artbeads Designer Seed Bead Blend. Cynthia created this necklace on the spot for a Facebook Live design challenge. Watch Cynthia make this necklace and more here.
Cut a length of jewelry wire approximately six inches long. Add a Czech glass 9x10mm bronze fire red briolette bead to the center of the wire and then add this pattern to each side of the briolette:
Add a copper crimp tube from the Beadalon Mixed Metals #2 crimp tube pack to one end of the wire. Bring the other end of the wire through the crimp tube in the opposite direction to form a hoop. Secure the crimp in place by flattening it with chain nose pliers.
Cut a length of jewelry wire approximately 20 inches long. Slide a gold crimp tube from the crimp pack onto the wire, followed by half of the TierraCast antique gold large beaded clasp set. Bring the wire back through the crimp tube and crimp in place.
Repeat two times. Then, add a seed bead, a tangerine Bicone, a seed bead, and three Forget-Me-Not beads. Add three 4mm round beads and three Forget-Me-Not beads. Repeat the original bead pattern once more. Then, add a seed bead, a Tangerine bicone, a seed bead, three Forget-Me-Not beads and three Czech glass rounds.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Sunset colors inspired this jewelry set. Coppery briolette drops draw attention in both the necklace and earrings, while Forget-Me-Not flower beads bring texture. Pops of yellow are provided by bicones and an Artbeads Designer Seed Bead Blend. Cynthia created this necklace on the spot for a Facebook Live design challenge. Watch Cynthia make this necklace and more here.
Cut a length of jewelry wire approximately six inches long. Add a Czech glass 9x10mm bronze fire red briolette bead to the center of the wire and then add this pattern to each side of the briolette:
Add a copper crimp tube from the Beadalon Mixed Metals #2 crimp tube pack to one end of the wire. Bring the other end of the wire through the crimp tube in the opposite direction to form a hoop. Secure the crimp in place by flattening it with chain nose pliers.
Cut a length of jewelry wire approximately 20 inches long. Slide a gold crimp tube from the crimp pack onto the wire, followed by half of the TierraCast antique gold large beaded clasp set. Bring the wire back through the crimp tube and crimp in place.
Repeat two times. Then, add a seed bead, a tangerine Bicone, a seed bead, and three Forget-Me-Not beads. Add three 4mm round beads and three Forget-Me-Not beads. Repeat the original bead pattern once more. Then, add a seed bead, a Tangerine bicone, a seed bead, three Forget-Me-Not beads and three Czech glass rounds.