On misty seaside mornings, there is nothing more relaxing than to watch the gentle waves lap up against the sandy shore. Small pebbles tumble and glint in the water, catching light off the sun and clumps of seaweed multiply with each wave. This bracelet captures the feel of calm beaches perfectly and will leave you absolutely Sea Struck.
Cut a length of jewelry wire approximately 10 inches long. Crimp one end of the wire to a 6mm 18 gauge copper open jump ring using a 14K/20 gold-filled 2x2mm crimp tube.
Repeat this patter two times, then add a TOHO, a cube spacer, a TOHO, three 4mm gemstone beads, a TOHO, a cube spacer and a final TOHO to the strand.
Repeat this pattern six times, then add a 4mm gemstone bead, an 8mm gemstone bead and a 4mm gemstone bead. Crimp the other end of this strand to a jump ring using a crimp tube. Add one end of the strand to the middle loop on half of the clasp and add the other end to the middle loop on the other half of the clasp.
Repeat this pattern three times, then add three 4mm gemstone beads and three seed beads to the strand. Use a crimp tube to attach the end of the strand to a jump ring. Add one end to the open loop on one half of the clasp and add the other end to the open loop on the other half of the clasp.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
On misty seaside mornings, there is nothing more relaxing than to watch the gentle waves lap up against the sandy shore. Small pebbles tumble and glint in the water, catching light off the sun and clumps of seaweed multiply with each wave. This bracelet captures the feel of calm beaches perfectly and will leave you absolutely Sea Struck.
Cut a length of jewelry wire approximately 10 inches long. Crimp one end of the wire to a 6mm 18 gauge copper open jump ring using a 14K/20 gold-filled 2x2mm crimp tube.
Repeat this patter two times, then add a TOHO, a cube spacer, a TOHO, three 4mm gemstone beads, a TOHO, a cube spacer and a final TOHO to the strand.
Repeat this pattern six times, then add a 4mm gemstone bead, an 8mm gemstone bead and a 4mm gemstone bead. Crimp the other end of this strand to a jump ring using a crimp tube. Add one end of the strand to the middle loop on half of the clasp and add the other end to the middle loop on the other half of the clasp.
Repeat this pattern three times, then add three 4mm gemstone beads and three seed beads to the strand. Use a crimp tube to attach the end of the strand to a jump ring. Add one end to the open loop on one half of the clasp and add the other end to the open loop on the other half of the clasp.