Fun textures and colors combine in this jewelry set. The Golem Design Studio pendant at the center of the necklace inspired the fun color palette, filled with wood beads, Czech glass, TierraCast, Anna Bronze, and Vintaj components. Becky challenged Cynthia on Facebook Live with these components to make a piece of jewelry and Cynthia created this set. You can watch Cynthia make this set and more here.
Cut a length of jewelry wire approximately seven inches long. Slide an antique brass 2x2mm crimp tube onto the end of the wire and then bring the wire through a TierraCast brass oxide pewter reversible Flora oval link and back through the crimp tube. Crimp in place.
Add the TierraCast brass oxide pewter botanical pinch bail to the Golem Design Studio stoneware large round pendant and add the pendant to the wire. Make a mirror image of the bead pattern on the other side of the pendant (some of the wood beads will fit under the bail)
Slide a crimp tube onto the wire, followed by a jump ring attached to half of the JBB antique brass-plated pewter flowers round toggle clasp. Bring the wire back through the crimp tube and crimp in place.
Add a crimp tube to the wire and then bring your wire through a 5mm jump ring attached to the other half of your clasp. Bring the wire back through the crimp tube and crimp in place.
,Cut a length of jewelry wire approximately ten inches long. Add an Anna bronze flower to the center of the wire. Add the following pattern to one side of the flower:
Repeat this pattern on the other side of the flower. Bring both ends of the wire up through a Vintaj filigree wrap bead.
Repeat the pattern on the other end of the wire. Bring both ends of the wire through a crimp tube and flatten the crimp tube in place with chain nose pliers.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Fun textures and colors combine in this jewelry set. The Golem Design Studio pendant at the center of the necklace inspired the fun color palette, filled with wood beads, Czech glass, TierraCast, Anna Bronze, and Vintaj components. Becky challenged Cynthia on Facebook Live with these components to make a piece of jewelry and Cynthia created this set. You can watch Cynthia make this set and more here.
Cut a length of jewelry wire approximately seven inches long. Slide an antique brass 2x2mm crimp tube onto the end of the wire and then bring the wire through a TierraCast brass oxide pewter reversible Flora oval link and back through the crimp tube. Crimp in place.
Add the TierraCast brass oxide pewter botanical pinch bail to the Golem Design Studio stoneware large round pendant and add the pendant to the wire. Make a mirror image of the bead pattern on the other side of the pendant (some of the wood beads will fit under the bail)
Slide a crimp tube onto the wire, followed by a jump ring attached to half of the JBB antique brass-plated pewter flowers round toggle clasp. Bring the wire back through the crimp tube and crimp in place.
Add a crimp tube to the wire and then bring your wire through a 5mm jump ring attached to the other half of your clasp. Bring the wire back through the crimp tube and crimp in place.
,Cut a length of jewelry wire approximately ten inches long. Add an Anna bronze flower to the center of the wire. Add the following pattern to one side of the flower:
Repeat this pattern on the other side of the flower. Bring both ends of the wire up through a Vintaj filigree wrap bead.
Repeat the pattern on the other end of the wire. Bring both ends of the wire through a crimp tube and flatten the crimp tube in place with chain nose pliers.
