This necklace is full of mysterious ocean beauty, from the Green Girl Studios pendant at the center to the ocean colors of the Czech glass, crystal, and seed beads. Cynthia was challenged live on Facebook to make this necklace. You can see her create this design and more here.
Cut a length of jewelry wire approximately 30 inches. Slide a sterling silver 2x2mm crimp tube onto the end, followed by a sterling silver 5.95mm open jump ring attached to half of the antiqued silver heritage clasp. Bring the wire back through the crimp tube and crimp in place.
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Opening and Closing Jump Rings Video
Repeat this pattern eight times and then add six seed beads to the strand. Add the Green Girl Studios pewter mermaid key pendant to the strand using a 5mm gunmetal-plated 18 gauge open jump ring. Make a mirror image of the bead pattern on the other side of the pendant.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
This necklace is full of mysterious ocean beauty, from the Green Girl Studios pendant at the center to the ocean colors of the Czech glass, crystal, and seed beads. Cynthia was challenged live on Facebook to make this necklace. You can see her create this design and more here.
Cut a length of jewelry wire approximately 30 inches. Slide a sterling silver 2x2mm crimp tube onto the end, followed by a sterling silver 5.95mm open jump ring attached to half of the antiqued silver heritage clasp. Bring the wire back through the crimp tube and crimp in place.
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Opening and Closing Jump Rings Video
Repeat this pattern eight times and then add six seed beads to the strand. Add the Green Girl Studios pewter mermaid key pendant to the strand using a 5mm gunmetal-plated 18 gauge open jump ring. Make a mirror image of the bead pattern on the other side of the pendant.
