Cut four pieces of half-hard, 20 gauge sterling silver wire approximately 3 inches long. Using a steel bench block and 4oz ball pein hammer, flatten one end of each wire to keep the beads from falling off.
Thread a different colored Swarovski 4mm faceted round onto each wire so the bead rests above the flattened end.
Create a wrapped loop opposite of the flattened end of each wire.
Attach two of the wrapped loop ends to one 0.75x4.6mm sterling silver open jump ring. Next, attach one JBB sterling silver leaf pendant and then the remaining two wrapped loop wire ends. Connect this jump ring to one 0.75x3.55mm sterling silver open jump ring, and then thread this jump ring onto one plain interchangeable leverback.
List of Components: Plain Interchangeable Lever Back (SS-LVR04, qty 2) JBB Sterling Silver Leaf Pendant (SS-PEND052, qty 2) Sterling Silver Open Jump Ring (0.75 x 3.55mm) (SS-OJR30-B, qty 2) Sterling Silver Open Jump Ring (0.75 x 4.60mm) (SS-OJR30-E, qty 2) Swarovski 5000 4mm Faceted Round Sapphire (5000-SAP4, qty 2) Swarovski 5000 4mm Faceted Round Light Siam (5000-SIALT4, qty 2) Swarovski 5000 4mm Faceted Round Fern Green (5000-FGN4, qty 2) Swarovski 5000 4mm Faceted Round Sunflower (5000-SUF4, qty 2)
Add all available items to your cart at once or edit the quantities
Nice choice! All or most of the products needed for this project are shown
below with quantities. Sometimes we sell out of components and aren’t able to order more from
the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up
the design and make it yours by substituting similar products or altering the entire color
scheme—it’s up to you!