Mixing Czech glass finishes is fun when making jewelry Cynthia used Halo, sueded gold, and metallic finishes all together in these bracelets. You can watch her create these bracelets and learn more about Czech glass finishes in this Artbeads Cafe episode.
Cut a length of jewelry wire approximately 11 inches long. Slide a TierraCast 2x2mm brass oxide brass crimp tube onto the wire, followed by a TierraCast brass oxide brass small oval open jump ring attached to half of the TierraCast brass oxide pewter heirloom clasp set. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Repeat this pattern until the bracelet is the desired length, keeping in mind the clasp adds about ¾ of an inch in length. Make sure to end the sequence with a 4mm fire-polished bead and a rondelle.
Repeat this pattern until the bracelet is the desired length, keeping in mind the clasp adds about an inch of length. Make sure to end the sequence with a rondelle.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Mixing Czech glass finishes is fun when making jewelry Cynthia used Halo, sueded gold, and metallic finishes all together in these bracelets. You can watch her create these bracelets and learn more about Czech glass finishes in this Artbeads Cafe episode.
Cut a length of jewelry wire approximately 11 inches long. Slide a TierraCast 2x2mm brass oxide brass crimp tube onto the wire, followed by a TierraCast brass oxide brass small oval open jump ring attached to half of the TierraCast brass oxide pewter heirloom clasp set. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Repeat this pattern until the bracelet is the desired length, keeping in mind the clasp adds about ¾ of an inch in length. Make sure to end the sequence with a 4mm fire-polished bead and a rondelle.
Repeat this pattern until the bracelet is the desired length, keeping in mind the clasp adds about an inch of length. Make sure to end the sequence with a rondelle.