Step one: Cut a length of cable chain to fit your wrist. In this example we used approximately 6¼ inches.
Step two: Attach the chain to the clasp using open jump rings. Remember when using jump rings to pull the two ends apart in a side to side direction.
Step three: Using the head pins and the wrapped loop technique, attach the pearls to the chain. For detailed instructions on how to make a wrapped loop, please visit How to make a wrapped loop under Jewelry Wire in our Handy Tips section. To keep the bracelet from looking too cluttered, allow 2 links on either side of the 12mm pearls and 1 for the smaller pearls. Use the 3 inch headpins for the 12mm pearls and the 1 ½ inch headpins for the smaller pearls.
Approximate Length: 7½ inches Approximate Cost: Under $30
List of Components:
Sterling silver 120 cable chain (925CH23, qty 1 ft)
8mm Swarovski pearl Tahitian look (5810-TAHI8, qty 3)
12mm Swarovski pearl Tahitian look (5810-TAHI12, qty 4)
6mm Swarovski pearl light grey (5810-LTGRY6, qty 8)
1 � inch sterling silver head pin, 22 gauge (SS-HP2X, qty 11)
3 inch sterling silver head pin, 22 gauge (SS-HP23, qty 4)
Sterling silver open jump ring (SS-OJR40-E, qty 2)
Sterling silver 14mm spring ring with figure eight ring (SS-SPR-D1, qty 1)
Tools used:
Lindstrom Supreme Cutter Side Micro-Beveled (TOOL-600)
Ergonomic chain nose pliers (TOOL-125)
Ergonomic round nose pliers (TOOL-127)
