Step one: Cut a length of Beadalon® jewelry wire to approximately six inches. Put one end in a Bead Stopper and slide a 2x2mm crimp tube on the wire. Follow with alternating crystal copper, light rose, tanzanite and fuchsia Swarovski modular beads until you use them all. Slide the 30mm Swarovski cosmic ring onto the strand of modular beads and wrap the beads around it to make a bail. Run the remaining end of the wire through the crimp tube and flatten it with chain nose pliers to close.
Step two: Pull a silky ribbon through the bail and tie at any length you like to wear this stunning necklace.
Estimated time: Less than 30 minutes Difficulty level: Beginner
