Carrie presented her bridesmaids with a choice of two sets of bridesmaid's jewelry each! Each one was unique and made to complement their personality. The girls made their choices, and here is what Sonja picked! Don't forget to check out the matching earrings and necklace.
Step one: Cut approximately 9 inches of ZambaPro jewelry wire and crimp the wire to one side of the sterling silver hammered spiral toggle using a 2x2mm sterling silver crimp tube. For help with Crimps, please visit the Handy Tips section of the Learning Center.
Step two: String a small antique silver-plated pewter Turkish spacer followed by a 6mm Swarovski aqua faceted round, five aqua and silver Swarovski roundelles, an antique silver-plated pewter Turkish spacer, five more roundelles, another Turkish spacer and an 8mm Swarovski faceted mocca roundelle. Add another Turkish spacer, a 10mm faceted round mocca crystal, aqua and silver roundelle and another 10mm mocca. This is your center bead, reverse the pattern to complete the bracelet.
Step three: Crimp the remaining wire to the other end of the bracelet and trim any excess wire.
Approximate size: 7 ½ inches
Approximate cost: Under $50.00
Estimated time: Under 1 hour
Difficulty level: Beginner
List of Components:
Swarovski 5000 6mm faceted round aqua (5000-AQUA6, qty 2)
Swarovski 5000 10mm faceted round mocca (5000-MOC10, qty 3)
Swarovski 5040 8mm faceted roundelle mocca (5040-MOC8, qty 2)
Sterling silver hammered spiral toggle (ISCL-0144, qty 1)
Swarovski 6mm silver and aqua roundelle (RDS-AQUA6, qty 32)
Antique silver-plated pewter small Turkish heishi spacer (SA-0425, qty 2)
Antique silver-plated pewter Turkish spacer (SA-5580, qty 8)
Sterling silver 2x2mm crimp tube (SS-CRM2, qty 2)
Zamba Pro 49 .019 30ft jewelry wire (ZP49-30F-019, qty 1)
Tools used:
Nipper tool (TOOL-101)
Crimper tool (TOOL-100) |
