These adorable bracelets are made to complement one another. For the child's bracelet, use the Ladybug Bracelet Kit. The instructions for Mom's design are listed below.
Step one: Cut a length of wire to approximately ten inches. Using 2x2mm sterling silver crimp tubes, attach one end to the flower end of the toggle clasp. Put all of your pewter charms on jump rings and set aside.
Step two: Randomly string your beads and charms, make sure to space the 12mm lampwork beads evenly for balance. We left about ¼ of an inch between each.
Step three: Crimp the remaining wire to the bar end of the toggle clasp and trim the excess.
Approximate length: 6½ inches Note: Because of the bulk of the beads on this bracelet, we recommend using the EZ bracelet sizer to get the correct inside diameter for your wrist. Approximate cost: Under $40 Estimated time: Less than one hour
