Celebrate the strength inside every survivor with this stunning necklace, and support breast cancer awareness through fashion. This asymmetrical piece's subtle sparkle makes it appealing to all women.
Step one:
Thread one sterling silver bead cap with leaf design, the Cande pavé 12mm light rose crystal clay round bead and another leaf design bead cap onto one sterling silver 24 gauge 1-inch eye pin. Finish it with a simple loop technique. Thread one sterling silver 8mm flared star bead cap, the Cande pavé 10mm crystal AB clay round bead and one more 8mm flared star bead cap onto another eye pin and finish with a simple loop. Thread one sterling 6mm flared star bead cap, the Cande pavé 8mm crystal AB clay round bead and one more 6mm flared star bead cap onto another eye pin and finish with a simple loop.
Step two:
Connect the eye pin loops of each together in ascending order of beads to form a chain, and then set aside.
Step three:
Thread one Swarovski 2mm faceted round in Rose, one 14x14mm white opaque heart-shaped pink ribbon bead and one more Rose faceted round onto the sterling silver 2-inch 3-ball head pin. Attach it to the JBB 22mm antique silver dimpled circular link by finishing it with a wrapped loop.
Step four:
Rest the sterling silver cut-out heart charm with Light Rose Swarovski crystals over the sterling silver heart charm with Light Rose Swarovski crystals. Attach them both to one sterling silver 0.90x4.60mm open jump ring. Watch our Handy Tip video to learn how to open and close a jump ring if you need help. Connect this jump ring to the circular link.
Step five:
Cut the sterling silver flat cable chain with 3mm beads into one strand approximately 9 inches long, or to your desired length. Attach one 0.5x3.0mm jump ring to one end. Connect this jump ring to a 0.90x4.60mm jump ring and connect it to the circular link.
Step six:
Cut one 1.25-inch strand of chain. Open the eye loop of the 12mm pavé bead and thread it onto one end of the chain, then close. Attach one 0.5x3.0mm sterling silver open jump ring to the open end of the chain. Connect this jump ring to one 0.90x4.60mm jump ring and connect it to the circular link.
Step seven:
Connect one end of the leftover chain to the 8mm pavé bead by opening the eye loop with chain nose pliers and sliding the chain on, then closing the loop. Hold up the circular link, allowing the two strands of chain to hang side by side. Trim the longer chain to match the length of the other.
Step eight:
Attach one 0.5x3.0mm jump ring to the open end of the recently cut chain. Then, connect this jump ring to the sterling silver heavy closed jump ring.
Step nine:
Attach one 0.5x3.0mm jump ring to the open end of the 9-inch chain from step five. Then, connect this jump ring to the 8mm round trigger clasp.
