Carrie presented her bridesmaids with a choice of two sets of bridesmaid’s jewelry each! Each one was unique and made to complement their personality. The girls made their choices, and here is what Jessica picked! Don’t forget to check out the matching earrings and necklace.
Step one: Cut approximately 9 inches of ZambaPro jewelry wire. Crimp one end of the wire to the loop end of your toggle clasp. String a sterling silver saucer bead followed by a Swarovski 4mm maroon pearl, 6mm aqua bicone and another pearl. Repeat this pattern 8 more times and finish with a sterling silver saucer bead. Crimp the remaining wire to the other end of your toggle clasp.
Step two: Cut a length of sterling silver chain to approximately 6 ½ inches and attach it to the toggle using small sterling silver open jump rings.
Approximate size: 7 inches Approximate cost: Under $40.00 Estimated time: Less than one hour Difficulty level: Beginner
List of Components:
Swarovski 5301 6mm faceted bicone aqua (5301-AQUA6, qty 9)
Swarovski 5810 4mm pearl maroon (5810-MAR4, qty 18)
Sterling granulated diamond curb chain (925CH104, qty 1)
Sterling silver 2x2mm crimp tube (SS-CRM2, qty 2)
Sterling silver open jump ring 0.75 x 3.05mm (SS-OJR30-A, qty 2)
Shiny saucer bead 5mm (SS-SAU4, qty 10)
Sterling silver toggle with 3mm cubic zirconia (SS-TOG54, qty 1)
Zamba Pro 49 .024 30ft jewelry wire (ZP49-30F-024, qty 1)
Tools used:
German ergonomic side cutters (TOOL-507)
Chain nose pliers (TOOL-106)
Nipper tool (TOOL-101)
Crimper tool (TOOL-100)
