This eye-catching bracelet can easily be made on your lunch hour! Personalize it with your favorite color of Czech glass teardrops.
Step One: Cut a length on ZambaPro 49 .019 jewelry wire approximately 1 ½ inches longer than the desired length of your finished bracelet. For this example we will use approximately 8 ½ inches.
Step Two: Attach the loop end of the Hill Tribe toggle clasp to the wire using a 2x2mm sterling silver crimp tube. If you are uncertain of how to use a crimp tube, please visit the Handy Tips section of the Learning Center.
Step Three: Begin stringing the bracelet with one 3mm gold filled round seamless bead followed by one 6x9mm red tiger's eye teardrop bead. Add another 3mm round, then two small Hill Tribe leaf pendants.
Step Three: The pattern will then go to, one 3mm gold-filled seamless round followed by three red tiger's eye teardrops, one round, two leaf pendants; repeat nine times.
Step Four: Finish with a 3mm gold bead, a single teardrop, and one more gold bead.
Step Five: Attach the end of the wire to the bar of the Hill Tribe toggle with a crimp tube. Trim excess wire.
Though this bracelet is simple to make, your friends don't have to know!
Approximate Length: 7 inches Approximate Cost: Under $30 (does not include stringing material)
List of Components:
Small Hill Tribe leaf pendant (HTS060, qty 20)
6x9mm red tiger's eye teardrop (CR-TD001, qty 29)
Hill Tribe toggle clasp (HTS062, qty 1)
3mm gold-filled round seamless bead (GF-RND3, qty 22)
2x2mm sterling silver crimp tube (SS-CRM2, qty 2)
ZambaPro 49 .019 30FT jewelry wire (ZP49-30F-019)
