
 |  |
 | This elegant graduation bracelet is strung on ZambaPro 49 .019 jewelry wire.
Step one: To begin cut a 10-inch piece of ZambaPro 49 .019 jewelry wire. Use a sterling silver 2x2mm crimp tube to crimp to an open jump ring. For help using crimp tubes please visit the Handy Tips section in the Learning Center. Attach the spring ring clasp and the diploma charm to the open jump ring.
Step two: String a 5mm sterling silver corrugated round bead followed by a CRYSTALLIZED™ 8mm Rosaline crystal bicone, another silver bead, and then a CRYSTALLIZED™ 8mm Capri blue crystal bicone. Repeat this until you have reached the middle of your bracelet.
Step three: When you arrive at the middle of your bracelet, add a closed jump ring with the graduation year of your choice. Continue stringing the rest of your beads. Using the same technique to string the center charm complete the bracelet by adding a silver bead, your last charm and another silver bead.
Step four: Crimp the other end of the jewelry wire to a closed jump ring.
Approximate length: 7 inches
Approximate cost: Under $20
Estimated time: Less than one hour
Difficulty level: Beginner
List of components:
Sterling silver 5mm corrugated round bead (SS-RND5-C, qty 14)
CRYSTALLIZED™ 8mm rosaline crystal bicone (5301-RO8, qty 6)
CRYSTALLIZED™ 8mm capri blue crystal bicone (5301-BLU8, qty 6)
Sterling silver star charm (CHARM246, qty 1)
Sterling silver diploma charm (CHARM241, qty 1)
Sterling silver medium closed jump ring (SS-CJR-ME, qty 4)
Sterling silver open jump ring (SS-OJR35-D, qty 4)
Spring silver 7mm spring ring (Closed Loop)(SS-SPR7, qty 1)
Sterling silver 2x2mm crimp tube (SS-CRM2, qty 2)
ZambaPro 49 .019 30ft jewelry wire (ZP49-30F-019)
Note: The 2003 charm has been discontinued. Click here to view all our school and education charms.
Tools used
Chain nose pliers (TOOL-106)
Nipper tool (TOOL-101)
Bead crimper tool (TOOL-100) |  |
- retailerId
- 29190d90
- view
- category
- GRBR201
|
 | |
Copyright © 1999-2009 Artbeads.com® All Rights Reserved.