Quick Hold Craft 2oz Tube

QTY

Measurements: 2oz
Place of Origin: USA

DIRECTIONS: To open, unscrew cap, hold tube upright until ready to use. Replace cap each time after use.

ALWAYS TEST A SMALL AREA BEFORE FULL USE.

USE AS A SEALANT: Apply directly to clean, dry surface; hold firmly until product sets. Additional coats may be applied; allow each layer to dry thoroughly. On leaking objects under pressure, tape over Quick Hold; additional coats may be applied over tape.

USE AS A CONTACT ADHESIVE: Spread coating on each surface to be joined together. Allow to harden for 5-10 minutes, then press both surfaces together. Quick Hold hardens by solvent evaporation and forms an immediate bond that is difficult to reposition after both adhesive coated surfaces are placed in contact and sufficient pressure is exerted to create full contact between both surfaces.

DRY TIME: Quick Hold will hold in about 2-3 minutes and reaches full cure in 2-6 hours. Cure time increases with lower temperature and decreases with higher temperatures.

TEMPERATURE RANGE: -40°F (-40°C) to 150°F (66°C)

UV RESISTANCE: For complete UV resistance paint over Quick Hold.

CHEMICAL RESISTANCE: Resistant to gasoline, alcohol, paint thinner, and most solvents.

WATER RESISTANCE: Water resistant immediately upon application.

NOTE: Quick Hold may damage finished surfaces. Avoid such contact until Quick Hold is completely dry.

CONTAINS METHYL ETHYL KETONE AND ACETONE. VAPOR HARMFUL. MAY CAUSE DIZZINESS, HEADACHE, OR NAUSEA. INTENTIONAL MISUSE BY DELIBERATELY CONCENTRATING AND INHALING THE CONTENTS MAY BE HARMFUL OR FATAL. CAUSES EYE, SKIN, NOSE AND THROAT IRRITATION. EXTREMELY FLAMMABLE LIQUID. Vapors can travel to a source of ignition and flash back. Keep away from heat, sparks, flame, pilot lights and all other sources of ignition. Do not smoke when using. Prevent build-up of vapors by opening all windows and doors to achieve cross ventilation. Keep container closed when not in use.

Use only with adequate ventilation. To avoid breathing vapors, open windows and doors or use other means to ensure fresh air entry during application and drying. Avoid contact with eyes, skin and clothing. Wash thoroughly after handling. Read directions on package before use.

FIRST AID: For eye contact flush with water for 15 minutes, call a physician. For skin contact wash thoroughly with soap and water. Get medical attention if irritation persists. If you experience difficulty breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately. Do not take internally. If swallowed, do not induce vomiting, call a physician or poison control center immediately.

KEEP OUT OF REACH OF CHILDREN