E-6000 is a unique adhesive formulated to meet high-performance industrial requirements. It adheres to more surfaces than virtually any other adhesive. E-6000 has exceptional adhesion to wood, metal, glass, fiberglass, ceramics, masonry and concrete. Not for use on Styrofoam. It also adheres strongly to leather, rubber, vinyl and many plastics. Because it is abrasion-resistant E-6000 may be used on high-wear surfaces. E-6000 maintains its flexible bond in cold temperatures and may be used to bond items subject to vibration. The clear E-6000 is not formulated for exposure to sunlight. For these applications, paint over E-6000 after it has cured.
CAUTION: Contains perchloroethylene. Harmful if inhaled. May cause dizziness, headache or nausea. Can cause skin and eye irritation. WARNING: This product contains a chemical known to the state of California to cause cancer.
Keep away from heat and flame. Contact with flame or hot surface may produce toxic gases. Use only with adequate ventilation. To avoid breathing vapors, open windows and doors or use other means to ensure fresh air entry during application and drying. Avoid prolonged or repeated contact with skin. Wash thoroughly after handling.
FIRST AID: If you experience difficulty breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical assistance immediately. If swallowed, do not induce vomiting; get medical attention. In case of eye contact, immediately flush with plenty of water for at least 15 minutes.
KEEP OUT OF REACH OF CHILDREN
DIRECTIONS 1. Please read all directions before using. 2. Surface should be clean, dry and free of dirt. Roughen surface before each use. 3. Puncture seal in neck of tube using pointer cap. 4. Test small area before use. 5. Best when used between 70 degrees and 85 degrees Fahrenheit. 6. Cure time increases with lower temperatures. 7. For maximum-strength bond, allow 24-72 hours dry time. 8. For joining non-porous surfaces, apply a thin coat to each surface wait 10 minutes and press surfaces together. 9. Clean uncured adhesive with acetone or citrus-based solvents. Cured material may be removed by cutting or scraping. 10. For further information, call (800) 767-4667.
