Carrie presented her bridesmaids with a choice of two sets of bridesmaid’s jewelry each! Each one was unique and made to complement their personality. After much deliberation, they each chose the styles they liked best, thinking those were the items they got to keep. They were right, but Carrie also surprised them with a thank you gift of the second set of jewelry on her wedding day! Be sure to check out Brook’s matching necklace and earrings.
Step one: Cut a length of ZambaPro 49 wire to approximately 10 inches. Using a 2x2mm sterling silver crimp tube, attach one end of the wire to the bar end of a sterling silver toggle clasp. For help using crimp tubes please visit the Handy Tips section in the Learning Center.
Step two: String a heishi spacer, followed by a Swarovski aqua bicone, another heishi, a mocca roundelle, a crystal round and another mocca roundelle. Continue this pattern five more times. Finish with a heishi spacer, an aqua bicone and another heishi spacer.
Step three: Crimp the other end of the wire to the loop end of the toggle clasp, and trim the excess wire.
Approximate size: 6 inches
Approximate cost: Under $40.00
Estimated time: Under an hour
Difficulty level: Beginner
List of Components:
Swarovski 5000 6mm faceted round crystal beads (5000-CRYS6, qty 6)
Swarovski 5040 6mm faceted roundelle mocca (5040-MOC6, qty 12)
Swarovski 5301 6mm faceted bicone aqua (5301-AQUA6, qty 7)
Antique silver-plated pewter small Turkish heishi spacer (SA-0425, qty 14)
Sterling silver 2x2mm crimp tube (SS-CRM2, qty 2)
Sterling silver toggle with 3mm aqua cubic zirconia (SS-TOG52, qty 1)
Zamba Pro 49 .019 30FT jewelry wire (ZP49-30F-019, qty 1)
Tools used:
Nipper tool (TOOL-101)
Crimper tool (TOOL-100) |
