Carrie presented her bridesmaids with a choice of two sets of bridesmaid’s jewelry each! Each one was unique and made to complement their personality. The girls made their choices, and here is what Brook picked! Don’t forget to check out the matching earrings and necklace.
Step one: Cut approximately 9 inches of ZambaPro jewelry wire and crimp one end of the wire to the round end of the toggle clasp using 2x2mm sterling silver crimp tubes. For help with crimping, please visit the Handy Tips section of our Learning Center.
Step two: String a Swarovski 6mm maroon pearl followed by a Swarovski crystal roundelle, 5.5mm simplicity crystal, another roundelle, maroon pearl, 6mm Swarovski aqua faceted round bead, 6mm white pearl and another aqua round.
Step three: Repeat this pattern three more times and finish with the pearl, roundelle, simplicity, roundelle, pearl combination. Crimp the remaining wire to the other side of the toggle clasp and trim excess wire.
Step four: Cover your crimp tubes with crimp covers to give your design that finishing touch!
Approximate size: 7 ½ inches
Approximate cost: Under $25.00
Estimated time: Under 1 hour
Difficulty level: Beginner
List of Components:
Swarovski 5000 6mm faceted round aqua (5000-AQUA6, qty 8)
Swarovski 5310 5.5mm simplicity crystal (5310-CRYS5, qty 5)
Swarovski 5810 6mm pearl maroon (5810-MAR6, qty 10)
Swarovski 5810 6mm pearl white (5810-WHITE6, qty 4)
Swarovski 6mm silver and crystal roundelle (RDS-CRYS6, qty 10)
Sterling silver 16mm spiral toggle clasp (ISCL-0048, qty 1)
Sterling silver 3.25mm spacer disc (SS-DISC, qty 8)
Sterling silver crimp cover (SS-CCOV01, qty 2)
Sterling silver 2x2mm crimp tube (SS-CRM2, qty 2)
Zamba Pro 49 .024 30ft jewelry wire (ZP49-30F-024, qty 1)
Tools used:
Nipper tool (TOOL-101)
Crimper tool (TOOL-100) |
